I bought 1000 meters of wire to settle a physics debate

The video in question for reference: [link] Interestingly, when I saw that I figured this channel for a goner because he was going to turn to the darkside, but quite contrary to expectations I feel like his channel has actually blossomed since then. His older videos are fine, but often just explaining concepts that you can find a lot of other explanations on, but some of his recent videos have rocked the boat even among physicists and IMHO he was ultimately proved to be correct for them. I particularly point at his videos about how nobody has measured the one-way speed of light ( [link] ), which was well-known among people very very deep in the field of relativity but not very well known outside of that (even amongst physicists in other fields, let alone lay people) and the electricity videos he's done in the last year ( [link] , [link] ) which attracted a whole whackload of "debunking" videos, which were themselves wrong (the best "bunking" video, if I may call it that, is probably AlphaPheonix's: [this video] , since he actually set up the experiment, albeit on a smaller scale). They aren't all of that caliber, but the knot theory video was very good too and not something I've seen a hundred times elsewhere, and the airships video that preceded that one clearly had a high degree of research put into it beyond just the hype.

His presentation is not very clear & imo the way he answers the question is not actually helpful in actually understanding what’s going on, but he is correct that current will flow in the far side almost immediately. As is made clearer in the documents he shared which contain his discussions with actual physicists, that current will be much smaller than the final current that flows all the way round the circuit, but it is there nevertheless. (In fact that current will initially flow whether or not the two halves of the flat ring are connected - if you think about it things have to work like this, because the middle of the system cannot “know” whether the far ends are connected until light has had time to get there & back. Relativity is absolute.) Take a look at the video made by YouTuber AlphaPhoenix where he constructs the entire thing on a smaller scale and demonstrates the effect with an oscilloscope: [this video] One way of viewing what’s going on here is to consider the two sides as a pair of large dipole antennas. When the switch (or in AlphaPheonix’s case, a transistor) is turned on, a pulse of electrons is pushed down one antenna, setting up a transient wave in the electromagnetic field around it which induces a current in the opposite direction in the “receiving” antenna on the other side. This happens regardless of whether the wired are connected in a loop or not! Physics is great.

Not really in the intuitive sense: [link] Someone actually went out and tested this: [this video] The electric field is very tightly constrained around the wire. The amount of energy that reaches the light through the gap is incredibly small, not nearly enough to turn on a real light bulb. The bulk of the energy does indeed have to take the path through the wire. I find that video usually leads people to an even less correct understanding than the marbles-in-a-tube analogy. The Veritasum video can essentially be summarized, "fun fact: two parallel wires act like an antenna, and an extremely small amount of energy reaches the other end before the rest of the energy takes the long path through the wire.

well, the truth turned out to be quite complicated; see also [this video] and [link] . the result is more complicated than just a single time delay, and the details of the experimental setup (like the wire diameter! and load impedance relative to transmission-line pulse impedance) matter a lot. in alphaphoenix's first experiment, putting 5 volts into a kilometer of wire, he got 0.2 volts across his resistor immediately, then after about 1.6μs, a jump up to about 2 volts, and then a gradual rise to 1.7 volts, some overshoot peaking after another 1.6μs, and then settling back down to the 1.7-volt level (derek's results in the linked video, which incidentally links to one of the two i linked above, were quantitatively different but qualitatively similar) the really unintuitive thing about this i think is that people think of electrical energy as flowing inside wires, when actually almost all of it flows around the wires, as veritasium explained quite ably. this is something people doing high-speed pcb layout have to deal with a lot in order to avoid emi problems as i understand it, derek has a ph.d. in physics, or actually in physics education research [link] . that doesn't mean he knows everything about physics, but generally my experience with people in ph.d. programs is that they're good at listening to counterarguments and admitting when they're wrong, and also seeking out experts before publishing (i think the veritasium video does contain a minor error in that it says electrons